Jorge Cardenas

• Diagnosed and repaired commercial HVAC systems, ensuring optimal performance and customer satisfaction.
• Conducted routine maintenance checks on refrigeration units to prevent system failures and ensure compliance.
• Collaborated with team members to troubleshoot complex service issues, enhancing problem-solving efficiency.
• Maintained accurate records of service calls and repairs for documentation and quality assurance purposes.
• Trained junior technicians on safety protocols and effective service techniques to improve overall team performance.
• Established strong relationships with clients through effective communication and timely service delivery, fostering loyalty.
• Improved response times by effectively managing schedules and prioritizing service calls based on urgency and location.
• Reduced callbacks through meticulous attention to detail in troubleshooting, repair, and documentation procedures.
• Supported fellow technicians with knowledge sharing, mentoring, and collaborative problem-solving efforts.
• Diagnosed and troubleshot problems, repairing, and restoring machines to peak performance.
• Troubleshot and diagnosed issues with HVAC and refrigeration units.
• Learn to by pass vfds and or replace and set to correct perimeters
• Learn to by pass economizer
• Set / adjust air flow on direct drive blower motor
• Replaced belts,pulleys and adjust airflow with them .

• Assembled components of HVAC systems using hand tools and power tools

• Installed and maintained HVAC systems, including furnaces, condenser, heat pumps ,mini splits, package units , thermostats, compressors, and condensers

• Read blueprints and diagram to understand installation requirements

• Replaced defective parts in HVAC systems and ensured proper functioning after repairs

• Drilled holes in floors, walls and roof to install equipment, using power saws, and drills

• Installed / replaced components to heating and cooling equipment, such as txvs,reversing valve , compressor , filter drier ,evaporator coil, air ducts, blower motor, outdoor fan motor,damper's, zone boards ,capacitors ,contractors , limit switch , pressure switch flame sensor , igniter ,inducer fan motor /assembly ,gas valve ,control board,

• Brazing

• Flushing line sets

• Pressure testing

• Recovery/vacuuming

• Charging unit

• Test and evaluate: Use specialized tools to check airflow, temperature, pressure, and refrigerant levels

• Capable Of installing 80 /96 % Furnace, heat pump , package unit ,pancake unit, mini split high/low volt condensate lines , gas lines ,brazening ,transitions,flue, Concentric kit, t-tops ,side wall jack ,fart fans, install tstat , run duct, propane conversion kit

• Know all codes

• Trouble shooting

• Diagnosing and replacing compartments

• Maintenance, coil cleaning checking compartment with multimeter /manometer,checking gas pressure ,amp draws testing capacitors ,contractors, duct cleaning

• Sales

• Experience training others

• Good customer service