Juan Armenta Pineda

• As a cdl driver/ hydrovac operator at Team Fishel I Start my day by inspecting assigned truck if any defect is found I report it immediately to mechanic and make a report .
• My duties here are pot holing existing utilities measure them and mark depth, I also open trench with hydrovac where excavating machinery can't be used. I also prepare bore shots for bore crew and bell holes, and assist crew with any help needed such as laboring
• When hydrovac is not needed I haul construction material with Dumptruck

• At M&J Interprises I was with the bore crew, my duties here were to prepare bore shots by exposing existing crossing utilities.
• I would also transport mini to construction job sites with Dumptrucks and trailer.
• 
  

• As a pipefitter my duties were to inspect new pipe for defects prior to installations, I was responsible for fusing elbows and T's were needed.
• Here I was also responsible for proper padding and shading of pipe with sand, and proper backfill.
• I was also a hydrovac operator here. I prepared camera holes with hydrovac. I also assisted crew in tie ins of gas pipes.

• Reviewed engineering plans for clarity and precision.
• Install PE gas pipe
• Abandoned old gas pipes and purge out gas with proper procedures.
• Make sure proper traffic set up is set .
• Sand and back fill trenches, locate gas lines
• Draw final prints after project is done.

• Assist operator as a spoter when excavating with construction equipment.
• Dig with shovel and big greens where machinery is not able to
• Install comunication boxes
• 
  

As a laborer i was responsible for sanding trenches before laying gas pipe, I would also back fill trenches

• Secure steel plates were needed