Elias-Leo Rodriguez
Waco,TX
Summary
Engineering technician seeking a position that I can contribute my knowledge, ability, and problem solving skills acquired in the electronic industry. Have experience with AC/DC circuitry,ability to use test equipment, and have over 10 years' experience in this related field.
Overview
19
19
years of professional experience
Work History
Field tech
Voltagrid- West
01.2022 - Current
- Monitoring gas using SCADA software
- Troubleshooting gas prs, leaks, temperature, and pressure
- Troubleshooting and maintenance on cat 3520 engines
- Rigging up and down 13.8Meg cables to cat 3520
- Switch gear and UPS troubleshooting
- Racking breakers in and out before every rig up.
Functional Test Technician
L3harris
10.2019 - 12.2021
- Work on all electronics coming off the aircraft
- Troubleshooting and testing RF and digital electronics
- Troubleshoot to component level
- Troubleshoot RF ports and amplifiers thru out system
- Testing and troubleshooting customer returns.
I & E Technician
Envase
01.2020 - 01.2021
- PLC troubleshooting using software to locate area of malfunction
- Conveyer maintenance, speed reduction and timing
- Motor swaps and polarity of motors for conveyers
- Over all plant operations to keep product going.
Engineering Technician
Texas Instrument DLP
05.2015 - 10.2019
- Characterization and Qualification of new and existing devices on Mirror Master testers
- Took measurement using class II laser for tilt angle of mirrors
- Did calibration on all test boards for all devices
- Supported Cmos Characterization of new devices at temps from -40C to 125C for automotive
- Tested devices and manipulated test programs on LTX tester.
RF Test Technician
Nvidia
08.2013 - 05.2015
- Qualification of new transceiver for production on U-flex tester
- Characterization of new transceiver device and corner splits using tempforcer at -20 to 85 Celsius
- RF matching on load board to achive 50 Ohm load using Smith chart
- Running assortment of test for Test Engineering to debug test program
- Check load impedance paths for RX and TX on new Engineering boards using Network Analyzer.
Test Technician
Esterline/Eclipse
11.2012 - 04.2013
- Tuned low and high band filters on RF modules
- Debugged RF reciever board to component level using Network analyzer
- Zilinx upload of firmware into new RF modules Resistance and voltage measurements on VME modules Used precision test equipment such as oscilloscopes, multi-meters, network analyzers and spectrum analyzers
- Implemented schematics, diagrams and written and verbal descriptions to effectively solve engineering project issues.
Product and Test Technician
Microtune, Inc. /Zoran
06.2005 - 11.2012
- Build and troubleshoot PCB boards to component level using oscilloscope and DMM from schematic
- Solder component onto PCB boards under the microscope
- Build RF/analog test fixtures for engineering and documenting all procedures for future fixtures
- Responsible for all PM, diagnostics, and calibrations on LTX- MX testers
- Responsible for PM and diagnostics on Roos tester Support engineering in calibration and modifications of RFtest fixtures
- Characterization, Hast,85/85,ESD testing on new products for engineering
- Data entry on all devices for Engineering
- Over temperature testing from -40c to 85c using Tempforcer on tester and bench
- Schematic capture for PCB layout using DX Designer software
- Diode curve tracing done on bench to determine the break down voltage
- OP life up to 1000 hr read point on sample lots for new products
- Responsible for ordering, building and maintaining inventory for engineering support of test modules, testfixtures, test hardware, and components needed for building of mater
- Culmination and evaluation of SWR's as specified by engineers
- Repair, modify and maintain tester hardware
- Fiber splicing HOM to SMF fiber
- Support production of devices by writing special work requests, assembly request, and by the disposition of low yielding lots
- Assisted engineers with problem solving, characterization, requirements and returned
- Construct characterization packages, which include data on latch up, electrical static discharge and AC and.
Education
Associate of Applied Science - Electronics/Semiconductor
Texas State Technical College
Waco, TX05.1999
Skills
- Strong leader
- AC/DC circuitry
- Detail-oriented
- Digital multimeter
- Exceptional time management
- Oscilloscope
- Cost Reduction
- Network Analyzer
- Troubleshoot to component level
- Signal generator
- SMT soldering skills
- Debugging
- Schematics
- Firmware
Personal Information
Willing To Relocate: Anywhere
Timeline
Field tech
Voltagrid- West
01.2022 - Current
I & E Technician
Envase
01.2020 - 01.2021
Functional Test Technician
L3harris
10.2019 - 12.2021
Engineering Technician
Texas Instrument DLP
05.2015 - 10.2019
RF Test Technician
Nvidia
08.2013 - 05.2015
Test Technician
Esterline/Eclipse
11.2012 - 04.2013
Product and Test Technician
Microtune, Inc. /Zoran
06.2005 - 11.2012
Associate of Applied Science - Electronics/Semiconductor
Texas State Technical College
Similar Profiles
Nathan C FallNathan C Fall
Level 2 Technician at VoltagridLevel 2 Technician at Voltagrid
Austin MayoAustin Mayo
Transport Driver at VoltagridTransport Driver at Voltagrid
Tessa Basa-FrancoTessa Basa-Franco
Project Coordinator at VoltaGrid, LLCProject Coordinator at VoltaGrid, LLC
Laura MataLaura Mata
Fulfillment Associate at AmazonFulfillment Associate at Amazon
Keyonna JohnsonKeyonna Johnson
Team Associate at Chartwells Higher EducationTeam Associate at Chartwells Higher Education