Mario Argueta
Alexandria,VA
Overview
9
9
years of professional experience
Work History
Carpenter
Structural Preservation Systems
Elkridge, MD
10.2020 - 05.2023
- Measured, cut and shaped wood materials to specifications using hand tools, such as saws
- Assembled furniture using glue, dowels, screws and nails.
- Repaired or replaced damaged structures or components.
- Constructed forms for concrete pours in accordance with building codes.
- Prepared surfaces by sanding or scraping off old finishes prior to refinishing them.
- Operated power tools safely when performing carpentry tasks such as drilling holes into lumber pieces.
- Maintained a clean job site at all times by disposing of debris properly after each shift.
- Performed various carpentry duties, including both rough and finish carpentry.
- Used various carpenter's hand tools, portable power tools and standard measuring instruments.
- Shaped or cut materials to proper measurements using hand tools, machines or power saws.
- Installed cabinets, base cabinets and crown molding.
- Cut and installed tile and hardwood flooring for residential and commercial buildings.
- Laid and stained oak casings and hardwood floors.
- Anchored and braced forms and other structures in place using nails, bolts, anchor rods, steel cables, planks, wedges and timbers.
- Covered subfloors with building paper and lay hardwood or parquet floors by nailing to subfloor or cementing to mastic base.
- Fabricated staircases, doors, window frames and other wooden components for buildings.
Commercial Roofer
Prospect Waterproofing
Sterling , VA
06.2017 - 06.2020
- Analyzed roofing plans and specifications to determine job requirements.
- Measured, cut, and installed insulation board, felt paper, and shingles for commercial roofs.
- Inspected existing roofs for damage or deterioration and created repair recommendations.
- Applied waterproof coatings to protect roofs from water damage.
- Utilized power tools such as nail guns, drills, saws and hammers while constructing new commercial roofs.
- Cut materials with hand tools such as scissors or utility knives according to measurements taken on site.
- Removed old roofing material prior to installation of new roofing system.
- Climbed ladders and scaffolding in order to reach difficult-to-access areas of the roof.
- Ensured that all debris was removed from the job site after each shift.
- Disassembled old roofs and disposed of components.
- Followed manufacturer specifications to remove old roofing materials and install new roofs.
- Repaired and maintained surface materials to make building exteriors weatherproof and waterproof.
- Applied plastic coatings and membranes, fiberglass or felt over sloped roofs to prepare for shingle installation.
- Kept records of daily work activities including materials used, time spent on tasks and any safety issues encountered.
- Performed maintenance checks on all equipment used during jobs.
- Installed rubber, metal and shingle roofing on different types of commercial buildings.
- Participated in all phases and types of commercial roofing.
- Repaired and replaced roof membrane, sub roofing, sheathing and base materials.
- Cut roofing paper to size and nailed and stapled paper to roof in overlapping strips to form base for roofing materials.
- Overlapped successive layers of roofing material, determining distance of overlap using chalk line, gauge on shingling hatchet and lines on shingles.
- Understood how to operate and maintain job site equipment safely and for maximum productivity.
- Cleaned or prepared construction sites to eliminate hazards.
- Added vapor barriers or insulating materials on flat roofs.
- Mopped and poured hot asphalt and tar onto roof base while applying asphalt and tar and gravel to roof.
Carpenter
Hatchers floors
Springfield, VA
09.2014 - 05.2016
- Measured, cut and shaped wood materials to specifications using hand tools, such as saws and chisels.
- Installed hardwood flooring, tile,baseboard,shoe molding fixtures and trim according to plans and blueprints.
- Fabricated staircases, doors, frames and other wooden components for buildings.
- Assembled furniture using glue, dowels, screws and nails.
- Repaired or replaced damaged structures or components.
- Operated power tools safely when performing carpentry tasks such as drilling holes into lumber pieces.
- Maintained a clean job site at all times by disposing of debris properly after each shift.
- Prepared surfaces by sanding or scraping off old finishes prior to refinishing them.
- Installed interior trim work such as baseboards and moldings around windows and doors.
- Laid out flooring patterns according to design templates or customer specifications.
- Performed various carpentry duties, including both rough and finish carpentry.
- Used various carpenter's hand tools, portable power tools and standard measuring instruments.
- Shaped or cut materials to proper measurements using hand tools, machines or power saws.
- Repaired or replaced damaged or defective parts using power tools and equipment.
- Cut and installed tile and hardwood flooring for residential and commercial buildings.
Education
High School Diploma -
W.T White
Dallas, TX06.2014
Skills
- Structural
- OSHA Regulations
- Hand and Power Tools
- Flooring Construction
- Structural Repairs
- Rough Carpentry Framing
- Rubber Roofing Membranes
- Able to Lift Over 50 Pounds
- Modified Bitumen Roofing
- EPDM Roofing Systems
- Power Tool Operation
- Structural Repair
- Precise
- Maintenance and Repairs
- Power Tools Operations
- Scaffold Building
- Concrete Mixing
- Waterproofing and Surface Restoration
- Power Grinding
- Hole and Crack Filling
- Chipping and Grinding
Timeline
Carpenter
Structural Preservation Systems
10.2020 - 05.2023
Commercial Roofer
Prospect Waterproofing
06.2017 - 06.2020
Carpenter
Hatchers floors
09.2014 - 05.2016
High School Diploma -
W.T White
Similar Profiles
Nehar MahmoodNehar Mahmood
Project Engineer Intern at Structural Preservation SystemsProject Engineer Intern at Structural Preservation Systems
BIANNY PICHARDOBIANNY PICHARDO
Office Manager at Structural Preservation SystemsOffice Manager at Structural Preservation Systems
Nancy TamayNancy Tamay
Project Manager at Structural Preservation SystemsProject Manager at Structural Preservation Systems
Devon RoseDevon Rose
Lead Man Technician at Structural Preservation SystemsLead Man Technician at Structural Preservation Systems
LINDSEY SCOTTLINDSEY SCOTT
Police Officer, Public Safety Diver at Metropolitan Police DepartmentPolice Officer, Public Safety Diver at Metropolitan Police Department