MATTHEW FRENCH

• WIPP SHAFT 5

-OPERATED VARIOUS EQUIPMENT

-DUMPED AND HAULED CONVEYANCE

-PREPARED ALL BOLTING AND MINING SUPPLIES FOR USE

• DENVER INTERNATIONAL AIRPORT SHAFT

-RAN EXCAVATOR TO DIG TO DEPTH

-INSTALLED STEEL RING BEAMS AND PANELS FOR RIB SUPPORT

-PRESSURE GROUTING TO ENSURE SHAFT INTEGRITY

• MAGNA UTAH SHAFTS

-RAN EXCAVATOR TO DIG TO DEPTH OF UTILITY SHAFT

-INSTALLED RING BEAMS AND PANELS FOR RIB SUPPORT

-PRESSURE GROUTING TO ENSURE SHAFT INTEGRITY

• PARK CITY, UTAH WATER TUNNEL

-INSTALLED/REPLACED LOW-KEY RAIL AND TRACKS TO ENUSRE SAFE TRAVEL IN WATER TUNNEL

-INSTALLED GROUND SUPPORT TO ENSURE TUNNEL INTEGRITY

• LARAMIE-POUDRE WATER TUNNEL

-INSTALLED LOW-KEY RAIL AND TIMBER TO ENSURE SAFE TRAVEL INSIDE TUNNEL

-INSTALLED GROUND SUPPORT TO REHAB TUNNEL, TO INCLUDE DAGS,SPLIT SETS, CABLE BOLTS ,ETC.

-MIXED AND SPRAYED WET/DRY SHOTCRETE

-DRILLED AND LOADED ROUNDS FOR NEW ADDITION TO TUNNEL

• Ensured precise load placement by accurately calculating load weights and determining proper rigging configurations.
• Performed pre-lift meetings with all involved parties to promote clear communication and understanding of roles and responsibilities throughout the lift process.
• Assisted crane operators with detailed load charts and calculations in order to guarantee safe weight distribution during the lift process.
• Minimized project delays by promptly identifying and addressing any rigging issues or malfunctions.

-Torque to spec well heads, frac stacks, drilling rigs and workover rigs.

-Troubleshot problems and developed successful solutions.

-Attached pumps and hoses to wellheads.

-Performed routine maintenance on vehicles and equipment.

-Transported chemicals, fluids, and pumping equipment.

-Connected hoses and pumps to wellheads, change water filters, and prepared equipment and vehicles for pumping.

-Prepared acids, chemicals, or dry cement to meet job-specific requirements.

-Repressurized wells to force oil to surface and drive gas to well bottom.

-Monitored pumps and flow lines for gas and fluid leaks.

-Observed pump control panels to verify proper pressure, density, and rate settings.

-Obtained evidence and prepared reports highlighting overlooked violations and required corrective actions.

-Determined baselines for inspections by reading and interpreting pump jack schematics and blueprint drawings.

-Documented inspections with online database and collected photographic evidence of work completed.

-Adjusted, cleaned, and repaired products or processing equipment to correct defects found during inspections.

-Identified specifications, inspection procedures and testing protocols by reading technical documentation.

-Conveyed inspection results, recommendations and needed repairs with written reports.