Michael Schavel

• Refurbish Genmega and Hyosung ATM's
• Inspect and test all refurbished ATM parts in shop
• Refurbish bill validators
• Completely disassemble NCR ATM's
• Clean Motherboard, Photo transistors, Optical Sensors, Magnetic Sensors, Pressure sensors
• Clean and lubricate Bearings, Shafts, Springs, Pressure plates
• Assemble Unit with new Belts, Rollers and replace defective parts
• Place Unit in Testbed feed money and record results on Excel Spread Sheet
• Troubleshoot and repair Units
• Perform preventative maintenance on Test Beds
• Attend daily morning meetings
• Clean shop and maintain safety guidelines
• Completed and processed paperwork and reports outlining proper and improper operations.
• Evaluated components and final products against quality standards and manufacturing specifications.
• Participated in team meetings to discuss progress and results, providing ideas and suggestions for improvement.
• Inspected quality of products, taking note of functionality, appearance and other specifications.

Performed visual inspections and non-destructive tests where appropriate.

• Inspected, Tested, Packed Medical Devices
• Inspected Sub assemblies in Wire Room
• Inspected assembled Stands for Medical Devices
• Inspected and tested Faceplate assemblies
• Inspected BOM's and Products for customer release
• Inspected Disposables for use with our Injectable Medical Devices
• Write non conforming reports on failed lots
• Inspect failed lots up to 1,000pcs daily
• Reprocess shipping damage and create shipping Labels
• Use computerized Drawings to inspect and measure incoming parts and take measurements using Veneer Calipers
• Attend all company meetings and safety training
• Cleaned and maintain work areas

• Set up blow mold and all associated equipment to minimize line changeover times
• Analyzed test results, machine error messages and information to diagnose equipment problems
• Resolved issues during startup and production while adhering to blow process sequence of operations
• Followed start-up, production and cleaning protocols, as well as completed required logs and documentation.

• Conducted quality assurance inspections on finished components and identified issues
• Followed outlined specifications to implement assembly plans
• Assembled components with minimal supervision, exceeding expected project milestones
• Completed durable assemblies and subassemblies with hand and power tools
• Set-Up and operate Heat Seal Machines
• Change Rollers and keep scrap count
• Load programs into Heat Seal machine.